<address id="npnhb"></address>
    <dfn id="npnhb"><dfn id="npnhb"><menuitem id="npnhb"></menuitem></dfn></dfn>

          <form id="npnhb"></form>

              <sub id="npnhb"><listing id="npnhb"><menuitem id="npnhb"></menuitem></listing></sub>

                <address id="npnhb"></address>

                  产品展示
                  PRODUCT DISPLAY
                  产品展示您现在的位置: 首页 > 产品展示 > 台湾仪鼎PICOTEST > PICOTEST测试讯号转换器 > J2101A中国台湾仪鼎PICOTEST专业测试讯号转换器

                  中国台湾仪鼎PICOTEST专业测试讯号转换器

                  更新时间:2020-03-31
                  浏览次数:1184
                  简要描述:

                  中国台湾仪鼎PICOTEST专业测试讯号转换器J2101A Low band corner frequency 達10Hz,可支援一般離線式電源供應器(off-line power supplies)之測量,45MHz之超高頻寬,足以對應目前及未來Z先進之穩壓器量測需求,超高頻寬,可達23 Octave,優異精確的低失真表現,5Ω終端,對待測電路的影響降至Z小,包括衰減功能來確保小信號的測量正確性

                  在线咨询

                  中国台湾仪鼎PICOTEST专业测试讯号转换器

                  J2101A Injection Transformer 10Hz~45MHz 

                   
                   
                   
                  iconLow band corner frequency 達10Hz,可支援一般離線式電源供應器(off-line power supplies)之測量
                  icon45MHz之超高頻寬,足以對應目前及未來zui先進之穩壓器量測需求
                  icon超高頻寬,可達23 Octave
                  icon優異精確的低失真表現
                  icon5Ω終端,對待測電路的影響降至zui小
                  icon包括衰減功能來確保小信號的測量正確性
                  icon詳細規格
                  中国台湾仪鼎PICOTEST专业测试讯号转换器
                  Product Information

                  The injection transformer is presently the prevalent method for connecting the network analyzer to the circuit being tested, and is primarily used for control loop stability measurements. The goal of the transformer is to inject a signal into the control loop being measured, without impacting the performance of the loop. In order to accomplish this to a reasonable degree, The transformer is isolated and therefore is capable of floating on a high voltage, such as a Power Factor Corrector (PFC), which is often close to 400VDC. Measuring voltages that exceed the voltage rating of the FRA inputs require attenuation probes.

                  The usable bandwidth of an injection transformer is generally significantly greater than the 3dB frequency limits. This is because the transformer itself is outside of the measurement, leading many to incorrectly believe that the transformer is a non-critical element.

                  The bandwidth of the transformer is strongly related to the terminating impedance. The most network analyzers provide a 50 Ohm oscillator source impedance. Assuming this impedance the optimal termination resistor is 5 Ohms. This significantly attenuates the injection signal, which is generally beneficial, as a common error in Bode measurements is using a signal which is too large, and therefore not a small signal measurement. An added benefit of this low value is that it can generally be left in circuit at all times, simplifying the connection to the network analyzer without appreciably impacting the output voltage of the circuit being tested.

                  Detailed Specifications:
                   
                  Performance at -10dBm input level
                  CharacteristicRating
                  DCR 
                  Ratio1:1
                  Termination Impedance5 Ohms
                  Nominal 3dB Bandwidth10Hz ~ 45MHz
                  Isolation Voltage600V
                  Isolation Capacitance150pF@1KHz
                  DC Current10mA
                  Temperature Range0 ~ 50°C
                  Maximum Altitude6000 Ft
                  联系方式
                  • 服务热线:

                    4009023318

                    13913158248

                    15295666126

                  • 公司电话:

                    0512-66315386

                  • 公司传真:

                    0512-66315383

                  在线客服
                  • 技术支持:
                  • 产品咨询:

                  最近中文字幕2018免费版,日韩精品无码免费专区网站,东北女人毛多水多牲交视频,一本加勒比HEZYO无码专区
                  扫一扫访问手机站扫一扫访问手机站
                  访问手机站